Eric Whittle's V8
- 3D
- Files
- Skills & Experience
- More Models
Skills
Working with Inventor since version 5
Primary Software Used: Autodesk Inventor
Modeling Software:
- AutoCAD
- Autodesk Inventor
Edwards Radial 5 Engine
By: Chris DabekNot finished from the plans I found, many parts have been changed to give it a more unique look.
SMG .45 Caliber
By: Chris DabekFound a book where someone shows how to make a homemade SMG, not really interested in making the thing, but it had dimensioned drawings! So I had to draw it up!! I didn't put the magazine in the 3d just so people that actually planned on making it
Category
Description
Guy at work said he would only make this if it was double the size, so I got to work making it. All is done from new files, minus Propeller, Springs, Gears, and Fasteners. Uploded to grabcad a while ago , might as well put it here too.
2 Comments
Michael Rehmus
Chris,
I interviewed Eric back in the early 2000's when he was in Oregon for a model engineering show. Give me your e-mail address and I'll send you the two-page article on him that I published in my magazine.
I'd like to share your 3D file with the magazine readers if you would permit that.
Best,
Mike Rehmus
editor@modelenginebuilder.com
I interviewed Eric back in the early 2000's when he was in Oregon for a model engineering show. Give me your e-mail address and I'll send you the two-page article on him that I published in my magazine.
I'd like to share your 3D file with the magazine readers if you would permit that.
Best,
Mike Rehmus
editor@modelenginebuilder.com
2 Comments
I interviewed Eric back in the early 2000's when he was in Oregon for a model engineering show. Give me your e-mail address and I'll send you the two-page article on him that I published in my magazine.
I'd like to share your 3D file with the magazine readers if you would permit that.
Best,
Mike Rehmus
editor@modelenginebuilder.com
Did you find this helpful?
Did you find this helpful?